iwi — Intel PRO/Wireless 2200BG/2225BG/2915ABG IEEE 802.11 driver

       The original iwi driver was written by Damien Bergamini <damien.bergamini@free.fr>.

Debian                                          October 15, 2015                                          IWI(4)

       The iwi driver provides support for Intel PRO/Wireless 2200BG/2915ABG  MiniPCI  and  2225BG  PCI  network
       adapters.   iwi  supports  station, adhoc, and monitor mode operation.  Only one virtual interface may be
       configured at any time.  For more information on configuring this device, see ifconfig(8).

       This driver requires the firmware built with the iwifw module to work.  For the  loaded  firmware  to  be
       enabled  for  use  the  license  at  /usr/share/doc/legal/intel_iwi.LICENSE  must be agreed by adding the
       following line to loader.conf(5):

             legal.intel_iwi.license_ack=1

iwi%d:devicetimeout  The driver will reset the hardware.  This should not happen.

       iwi%d:firmwareerror  The onboard microcontroller crashed for some reason.  The driver  will  reset  the
       hardware.  This should not happen.

       iwi%d:timeoutwaitingforfirmwareinitializationtocomplete  The onboard microcontroller failed to
       initialize in time.  This should not happen.

       iwi%d:couldnotloadfirmwareimage'%s'  The driver  failed  to  load  the  firmware  image  using  the
       firmware(9)  subsystem.   Verify  the  iwifw(4)  firmware  module  is installed and the license agreement
       loader(8) tunable has been set.

       iwi%d:couldnotloadbootfirmware  An attempt  to  upload  the  boot  firmware  image  to  the  onboard
       microcontroller failed.  This should not happen.

       iwi%d:couldnotloadmicrocode  An attempt to upload the microcode image to the onboard microcontroller
       failed.  This should not happen.

       iwi%d:couldnotloadmainfirmware  An attempt  to  upload  the  main  firmware  image  to  the  onboard
       microcontroller failed.  This should not happen.

       Join an existing BSS network (i.e., connect to an access point):

             ifconfig wlan create wlandev iwi0 inet 192.168.0.20 \
                 netmask 0xffffff00

       Join a specific BSS network with network name “my_net”:

             ifconfigwlancreatewlandeviwi0ssidmy_netup

       Join a specific BSS network with 64-bit WEP encryption:

             ifconfig wlan create wlandev iwi0 ssid my_net \
                     wepmode on wepkey 0x1234567890 weptxkey 1 up

       Join a specific BSS network with 128-bit WEP encryption:

             ifconfig wlan create wlandev iwi0 wlanmode adhoc ssid my_net \
                 wepmode on wepkey 0x01020304050607080910111213 weptxkey 1

/usr/share/doc/legal/intel_iwi.LICENSEiwi firmware license

       iwi — Intel PRO/Wireless 2200BG/2225BG/2915ABG IEEE 802.11 driver

iwifw(4), pci(4), wlan(4), wlan_ccmp(4), wlan_tkip(4), wlan_wep(4), ifconfig(8), wpa_supplicant(8)

       To compile this driver into the kernel, include the following lines in your kernel configuration file:

             deviceiwideviceiwifwdevicepcidevicewlandevicefirmware

       Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

             if_iwi_load="YES"

       In  both  cases,  place  the  following  line  in loader.conf(5) to acknowledge the firmware license (see
       below):

             legal.intel_iwi.license_ack=1