uvisor — USB support for the PalmOS based PDAs

       The  code  to  provide  multiple  ucom(4)  instances  has not yet been ported from NetBSD.  It is unclear
       whether this driver works in its current state.

Debian                                           April 26, 2017                                        UVISOR(4)

       The  uvisor  driver  provides support for USB based PalmOS PDAs, like Handspring Visor, Palm Mxxx series,
       and Sony Clie.

       The device is accessed through the ucom(4) driver which makes it behave like a tty(4).   The  device  has
       several  ports  for  different  purposes,  each  of them gets its own ucom(4) device.  The attach message
       describes the purpose of each port.

       The usual Pilot tools can be used to access the attached device on the HotSync port.

/dev/ttyU*       for callin ports
       /dev/ttyU*.init/dev/ttyU*.lock  corresponding callin initial-state and lock-state devices

       /dev/cuaU*       for callout ports
       /dev/cuaU*.init/dev/cuaU*.lock  corresponding callout initial-state and lock-state devices

       The uvisor driver supports the following devices:

       •   Aceeca Mez1000 RDA
       •   Handspring Treo
       •   Handspring Treo 600
       •   Handspring Visor
       •   Palm I705
       •   Palm M125
       •   Palm M130
       •   Palm M500
       •   Palm M505
       •   Palm M515
       •   Palm Tungsten T
       •   Palm Tungsten Z
       •   Palm Zire
       •   Palm Zire 31
       •   Sony Clie 4.0
       •   Sony Clie 4.1
       •   Sony Clie 5.0
       •   Sony Clie PEG-S500C
       •   Sony Clie NX60
       •   Sony Clie S360
       •   Sony Clie TJ37

       The uvisor driver was adopted from NetBSD 1.5 in August 2002.  This manual page was adopted  from  NetBSD
       by Tom Rhodes <trhodes@FreeBSD.org> at that time.

       uvisor — USB support for the PalmOS based PDAs

tty(4), ucom(4), usb(4)

       To compile this driver into the kernel, place the following lines in your kernel configuration file:

             deviceusbdeviceucomdeviceuvisor

       Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

             uvisor_load="YES"