uvscom — USB support for SUNTAC Slipper U VS-10U serial adapters driver

       The  uvscom  driver provides support for the SUNTAC Slipper U VS-10U chip.  Slipper U is a PC Card to USB
       converter for data communication card adapters.

       The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

/dev/ttyU*       for callin ports
       /dev/ttyU*.init/dev/ttyU*.lock  corresponding callin initial-state and lock-state devices

       /dev/cuaU*       for callout ports
       /dev/cuaU*.init/dev/cuaU*.lock  corresponding callout initial-state and lock-state devices

       The uvscom driver supports the following adapters:

       •   DDI Pocket Air H" C@rd
       •   DDI Pocket Air H" C@rd 64
       •   NTT P-in
       •   NTT P-in m@ster

       The uvscom driver first appeared in FreeBSD and later in NetBSD 1.6.  This manual page was  adopted  from
       NetBSD by Tom Rhodes <trhodes@FreeBSD.org> in April 2002.

Debian                                           April 26, 2017                                        UVSCOM(4)

       uvscom — USB support for SUNTAC Slipper U VS-10U serial adapters driver

tty(4), ucom(4), usb(4)

       To compile this driver into the kernel, place the following lines in your kernel configuration file:

             deviceusbdeviceucomdeviceuvscom

       Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

             uvscom_load="YES"