dlt_gateway.conf - DLT configuration file for gateway

Author

Thanh Bui Nguyen Quoc (thanh.buinguyenquoc (at) vn (dot) bosch (dot) vn)

Bugs

See Github issue: <https://github.com/COVESA/dlt-daemon/issues>

Copyright

Description

The configuration file dlt_gateway.conf allows to configure the different runtime behaviour of gateway in Multinode feature. The configuration file is written in an INI file format and contains information about different connect‐ ed passive nodes. If Multinode feature is enabled, dlt-daemon loads by default the configuration file /etc/dlt_gate‐ way.conf. An alternative configuration file can be loaded by changing GatewayConfigFile in dlt.conf(5).

General Section

Interval Time interval for reconnection to passive Node in second. Default: 1

Name

dlt_gateway.conf - DLT configuration file for gateway

Passivenode Section

Each passive node’s connection parameters are specified in a unique numbered separate section ([PassiveNode{1,2, ...N}]). Example: [PassiveNode1] IPaddress Because TCP is the only supported communication channel, the IPaddress and Port of the Passive DLT Daemon has to be specified. IP Address of passive node. Mandatory Port TCP port. Default 3490 is used if no port is specified. Default: 3490 EcuID ECU identifier of passive node. Mandatory. Connect With the Connect property it is possible to specify when the Gateway DLT Daemon shall connect to the pas‐ sive node. Default: OnStartUp The following values are allowed: OnStartup The Gateway DLT Daemon tries to connect to the Passive DLT Daemon immediately after the Gateway DLT Daemon is started. OnDemand The Gateway DLT Daemon tries to connect to the Passive DLT Daemon when it receives a connection request. Timeout Stop connecting to passive node, if not successful after 10 retries. After of retries, the connection to passive Node is marked as DISABLED. It means there is no any retry anymore. Set to 0 for endless retry. Default: 10 SendControl Send following control messages after connection is established. Optional. Default: disabled Supported Control messages: DLT_SERVICE_ID_GET_LOG_INFO 0x03 DLT_SERVICE_ID_GET_DEFAULT_LOG_LEVEL 0x04 DLT_SERVICE_ID_GET_SOFTWARE_VERSION 0x13 SendSerialHeader Send Serial Header with control messages. Value in dlt.conf(5) is used as default if not specified. Default: disabled SendPeriodicControl Send following control messages periodically. Default: disabled Format: control:interval[in seconds]