Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD

       Configuration classes used by Config::Model

       generated from LCDd.conf

Brightness
       Set the initial brightness (4 steps 0-250, 251-500, 501-750, 751-1000)  Optional.Typeinteger.

       upstream_default value :
           1000

   Device
       Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1.  Optional.Typeuniline.

       default value :
           /dev/ttyS1

   ISO_8859_1
       enable ISO 8859 1 compatibility  Optional.Typeboolean.

       upstream_default value :
           yes

   OffBrightness
       Set  the initial off-brightness This value is used when the display is normally switched off in case LCDd
       is inactive (4 steps 0-250, 251-500, 501-750, 751-1000)  Optional.Typeinteger.

       upstream_default value :
           0

   Port
       Number of Custom-Characters. default is display type dependent Custom-Characters=0 Portaddress where  the
       LPT is. Used in parallel mode only. Usual values are 0x278, 0x378 and 0x3BC.  Optional.Typeuniline.

       default value :
           0x378

   PortWait
       Set parallel port timing delay (us). Used in parallel mode only.  Optional.Typeinteger.

       upstream_default value :
           2

   Size
       Specifies the size of the VFD.  Optional.Typeuniline.

       default value :
           20x2

   Speed
       set the serial port speed  Optional.Typeenum.choice:'1200','2400','9600','19200','115200'.

       upstream_default value :
           9600

   Type
       Specifies  the  displaytype.  0 NEC (FIPC8367 based) VFDs.  1 KD Rev 2.1.  2 Noritake VFDs (*).  3 Futaba
       VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (*) 6 Futaba NA202SD08FA (allmost  IEE  compatible)  7  Samsung
       20S207DA4  and  20S207DA6  8  Nixdorf  BA6x / VT100 (* most should work, not tested yet.)  Optional.Typeuniline.

       upstream_default value :
           0

   use_parallel
       "no" if display connected serial, "yes" if connected parallel.  I.e. serial by default.   Optional.Typeuniline.

       upstream_default value :
           no

       Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD

       •   cme

perl v5.40.1                                       2025-03-04             Config::Model::...LCDd::serialVFD(3pm)