io_uring_resize_rings - resize the SQ and CQ rings

       The  io_uring_resize_rings(3) function performs resizes the SQ and/or CQ ring associated with ring by the
       parameters specified in p.

       The p argument must be filled in with the appropriate information for the resize operations, most notably
       the sq_entries and cq_entries fields must be filled out. The flags field can also be set, see  below  for
       potential values that may be used with a resize operation.

       It's  fairly  uncommon  to  need to resize the SQ ring, but not that uncommon that the CQ ring would need
       resizing. For networked workloads, it can be hard to appropriately size the CQ ring upfront, as it's  not
       always  known  what  load  a  given  ring will see. If overflow conditions are seen for the CQ ring, then
       resizing it larger may be a good idea.

       When a ring is resized, any pending SQ or CQ entries are copied along the way. It is not legal to  resize
       a CQ ring that is in an overflow condition, and attempting to do so will fail.

       Currently  doesn't  support  resizing  rings setup with IORING_SETUP_NO_MMAP.  This is purely a liburing
       limitation, the kernel does support it.

       Also note that ring resizing is currently only supported on rings setup with IORING_SETUP_DEFER_TASKRUN.
       Attempting to resize differently configured rings will result in an -EINVAL error.

       Valid flags in flags:

       IORING_SETUP_CQSIZE
              If this isn't set, then the CQ ring size is set based on the specified SQ ring size.  The  default
              is  twice  as  many  CQ ring entries as there are SQ ring entries. If set, then cq_entries will be
              used to size the CQ ring.

       IORING_SETUP_CLAMP
              If set, then SQ and CQ ring entries are clamped to the maximum  allowable  size,  if  they  exceed
              that. If not set, setting sizes too large will cause the operation to fail.

       Other   flags   are   inherited   from   the   way   the   ring  was  setup,  that  includes  flags  like
       IORING_SETUP_NO_SQARRAY,IORING_SETUP_SQE128,IORING_SETUP_CQE32, and IORING_SETUP_NO_MMAP.

       Other fields in p should be cleared to zero.

       Available since kernel 6.13.

       Also see io_uring_setup(2) for a detailed description of the setup flags.

       io_uring_resize_rings - resize the SQ and CQ rings

       Returns 0 on success, and < 0 on failure. Potential common failure cases:

       -EEXIST
              Attempting to resize a ring  setup  with  IORING_SETUP_SINGLE_ISSUER  and  the  resizing  task  is
              different from the one that created/enabled the ring.

       -EFAULT
              Copying of p was unsuccessful.

       -EINVAL
              Invalid flags were specified for the operation

       -EINVAL
              Attempt to resize a ring not setup with IORING_SETUP_DEFER_TASKRUN.

       -EOVERFLOW
              The values specified for SQ or CQ entries would cause an overflow.

io_uring_setup(2)

liburing-2.9                                    October 29, 2024                        io_uring_resize_rings(3)

#include<liburing.h>intio_uring_resize_rings(structio_uring*ring,structio_uring_params*p);