plmtex3 - Write text relative to viewport boundaries in 3D plots

side (PLCHAR_VECTOR(3plplot), input)
              An  ascii  character  string  specifying  the  side  of the viewport along which the text is to be
              written. The string should contain one or more of the following characters: [xyz][ps][v]. Only one
              label is drawn at a time, i.e. xyp will only label the X axis, not both the X and Y axes. x: Label
              the X axis.  y: Label the Y axis.  z: Label the Z axis.  p: Label the primary axis. For Z this  is
              the  leftmost  Z axis. For X it is the axis that starts at y-min. For Y it is the axis that starts
              at x-min.  s: Label the secondary axis.  v: Draw the text perpendicular to the axis.

       disp (PLFLT(3plplot), input)
              Position of the reference point of string, measured outwards from the specified viewport  edge  in
              units of the current character height.  Use negative disp to write within the viewport.

       pos (PLFLT(3plplot), input)
              Position of the reference point of string along the specified edge, expressed as a fraction of the
              length of the edge.

       just (PLFLT(3plplot), input)
              Specifies  the position of the string relative to its reference point.  If just=0. , the reference
              point is at the left and if just=1. , it is at the right of the string.  Other values of just give
              intermediate justifications.

       text (PLCHAR_VECTOR(3plplot), input)
              A UTF-8 character string to be written out.

       Many developers (who are credited at http://plplot.org/credits.php) have contributed to PLplot  over  its
       long history.

       Writes  text  at a specified position relative to the viewport boundaries.  Text may be written inside or
       outside the viewport, but is clipped at the subpage boundaries.  The reference point  of  a  string  lies
       along  a  line  passing  through  the string at half the height of a capital letter.  The position of the
       reference point along this line is determined by just, and the position of the reference  point  relative
       to the viewport is set by disp and pos.

       Redacted form: plmtex3(side,disp,pos,just,text)

       This function is used in example 28.

plmtex3 - Write text relative to viewport boundaries in 3D plots

       PLplot documentation at http://plplot.org/documentation.php.

                                                   July, 2025                                   PLMTEX3(3plplot)

plmtex3(side, disp, pos, just, text)