SDL_IOFromConstMem - Use this function to prepare a read-only memory buffer for use with SDL_IOStream .

       This function is available since SDL 3.2.0.

       This function sets up an SDL_IOStream
        struct based on a memory area of a certain size. It assumes the memory area is not writable.

       Attempting to write to this SDL_IOStream
        stream will report an error without writing to the memory buffer.

       This  memory  buffer  is not copied by the SDL_IOStream ; the pointer you provide must remain valid until
       you close the stream. Closing the stream will not free the original buffer.

       If you need to write to a memory buffer, you should use

       SDL_IOFromMem () with a writable buffer of memory instead.

       The following properties will be set at creation time by SDL:

       • SDL_PROP_IOSTREAM_MEMORY_POINTER :
         this will be the mem parameter that was passed to this function.

       • SDL_PROP_IOSTREAM_MEMORY_SIZE_NUMBER :
         this will be the size parameter that was passed to this function.

mem    a pointer to a read-only buffer to feed an SDL_IOStream
               stream.

       size   the buffer size, in bytes.

       Defined in SDL3/SDL_iostream.h

       SDL_IOFromConstMem - Use this function to prepare a read-only memory buffer for use with SDL_IOStream .

       ( SDL_IOStream
        *) Returns a pointer to a new

       SDL_IOStream
        structure or NULL on failure; call

       SDL_GetError () for more information.

•(3),  SDL_IOFromMem(3),  •(3),  SDL_CloseIO(3),  •(3),   SDL_ReadIO(3),   •(3),   SDL_SeekIO(3),   •(3),
       SDL_TellIO(3)

Simple Directmedia Layer                           SDL 3.2.10                              SDL_IOFromConstMem(3)

#include"SDL3/SDL.h"SDL_IOStream*SDL_IOFromConstMem(constvoid*mem,size_tsize);

       It is safe to call this function from any thread.