dcb-dcbx - show / manipulate port DCBX (Data Center Bridging eXchange)

       Petr Machata <me@pmachata.org>

iproute2                                        13 December 2020                                     DCB-DCBX(8)

       Data Center Bridging eXchange (DCBX) is a protocol used by DCB devices to exchange configuration
       information with directly connected peers. The Linux DCBX object is a 1-byte bitfield of flags that
       configure whether DCBX is implemented in the device or in the host, and which version of the protocol
       should be used.  dcbdcbx is used to access the per-port Linux DCBX object.

       There are two principal modes of operation: in host mode, DCBX protocol is implemented by the host LLDP
       agent, and the DCB interfaces are used to propagate the negotiate parameters to capable devices. In lld-managed mode, the configuration is handled by the device, and DCB interfaces are used for inspection of
       negotiated parameters, and can also be used to set initial parameters.

       Put the DCB engine into the "host" mode of operation, and use IEEE-standardized DCB interfaces:

       # dcb dcbx set dev eth0 host ieee

       Show what was set:

       # dcb dcbx show dev eth0
       host ieee

       Exit status is 0 if command was successful or a positive integer upon failure.

       dcb-dcbx - show / manipulate port DCBX (Data Center Bridging eXchange)

       When used with dcbdcbxset, the following keywords enable the corresponding configuration. The keywords
       that are not mentioned on the command line are considered disabled. When used with show, each enabled
       feature is shown by its corresponding keyword.

       hostlld-managed
              The  device is in the host mode of operation and, respectively, the lld-managed mode of operation,
              as described above. In principle these two keywords are mutually exclusive, but  dcbdcbx  allows
              setting both and lets the driver handle it as appropriate.

       ceeieee   The  device  supports CEE (Converged Enhanced Ethernet) and, respectively, IEEE version of the DCB
              specification. Typically only one of these will be set, but dcbdcbx does not mandate this.

       static indicates the engine supports static configuration. No actual negotiation is performed, negotiated
              parameters are always the initial configuration.

       Report any bugs to the Network Developers mailing list <netdev@vger.kernel.org> where the development and
       maintenance is primarily done.  You do not have to be subscribed to the list to send a message there.

dcb(8)

dcb [ OPTIONS ] dcbx { COMMAND | help }

       dcbdcbxshowdev DEV

       dcbdcbxsetdev DEV [ host ] [ lld-managed ] [ cee ] [ ieee ] [ static ]