airtun-ng - a virtual tunnel interface creator for aircrack-ng

airtun-ng  creates  a  virtual  tunnel  interface  (atX)  for  sending  arbitrary IP packets by using raw
       ieee802.11 packet injection.

airtun-ng -a 00:14:22:56:F3:4E -t 0 -y keystream.xor wlan0

       airtun-ng - a virtual tunnel interface creator for aircrack-ng

-H,--help
              Shows the help screen.

       -x<pps>
              Sets maximum number of packets per second.

       -a<BSSID>
              Specifies the BSSID for the iee802.11 header. In WDS Mode this sets the Receiver.

       -h<SMAC>
              Specifies the source MAC for the iee802.11 header.

       -i<iface>
              Sets the capture interface.

       -r<file>
              Specifies a file to read 802.11 frames.

       -y<PRGA-file>
              Is the name of the file, which provides the  keystream  for  WEP  encoding.  (No  receiving,  just
              transmitting of IP packets.)

       -w<WEP-key>
              This is the WEP key to en-/decrypt all traffic going through the tunnel.

       -e<ESSID>
              Sets the target network SSID (use with -p).

       -p<passphrase>
              Use this WPA passphrase to decrypt packets (use with -a and -e).

       -t<tods>
              Defines the ToDS and FromDS bit in the ieee802.11 header. For tods=1, the ToDS bit is set to 1 and
              FromDS  to  0,  while tods=0 sets them the other way around. If set to 2, it will be tunneled in a
              WDS/bridge.

       -m<netmask>,--netmask<netmask>
              Filters networks based on bssid ^ netmask combination. Needs -d, used in replay mode.

       -d<BSSID>,--bssid<BSSID>
              Filters networks based on the <BSSID>. Used in replay mode.

       -f,--repeat
              Enables replay mode. All read frames, filtered by  bssid  and  netmask  (if  specified),  will  be
              replayed.

       -s<transmitter>
              Set Transmitter MAC address for WDS Mode.

       -b     Bidirectional  mode.  This  enables  communication in Transmitter's AND Receiver's networks. Works
              only if you can see both stations.

airbase-ng(8)aireplay-ng(8)airmon-ng(8)airodump-ng(8)airodump-ng-oui-update(8)airserv-ng(8)besside-ng(8)easside-ng(8)tkiptun-ng(8)wesside-ng(8)aircrack-ng(1)airdecap-ng(1)airdecloak-ng(1)airolib-ng(1)besside-ng-crawler(1)buddy-ng(1)ivstools(1)kstats(1)makeivs-ng(1)packetforge-ng(1)wpaclean(1)airventriloquist(8)

Version 1.7.0                                       May 2022                                        AIRTUN-NG(8)

airtun-ng [options] <interface name>