smp_rep_zone_man_pass - invoke REPORT ZONE MANAGER PASSWORD function

       Written by Douglas Gilbert.

       The SMP REPORT ZONE MANAGER PASSWORD function was introduced in SAS-2 .

       Copyright © 2011 Douglas Gilbert
       This software is distributed under a FreeBSD license. There is NO warranty; not even for  MERCHANTABILITY
       or FITNESS FOR A PARTICULAR PURPOSE.

       Sends a SAS Serial Management Protocol (SMP) REPORT ZONE MANAGER PASSWORD function  requests  to  an  SMP
       target. The SMP target is identified by the SMP_DEVICE and the --sa=SAS_ADDR. Depending on the interface,
       the  SAS_ADDR may be deduced from the SMP_DEVICE. The mpt interface uses SMP_DEVICE to identify a HBA (an
       SMP initiator) and needs the additional ,N to differentiate between HBAs if there are multiple present.

       smp_rep_zone_man_pass - invoke REPORT ZONE MANAGER PASSWORD function

       Mandatory arguments to long options are mandatory for short options as well.

       -F, --fpass=FP
              where FP is the name of a file which the password will be written to.  The default action (in  the
              absence of this option) is to write the password to stdout.

       -h, --help
              output the usage message then exit.

       -H, --hex
              output  the  response (less the CRC field) in hexadecimal. To only see the password in hexadecimal
              use the --phex option.

       -I, --interface=PARAMS
              interface specific parameters. In this case "interface" refers to the path through  the  operating
              system to the SMP initiator. See the smp_utils man page for more information.

       -p, --phex
              Output  the  password  in  comma  separated  hexadecimal  bytes. In the absence of this option the
              password is output in ASCII surrounded by single quotes.  Note the hexadecimal  bytes  are  output
              with a hex indication (i.e. there is nos leading "0x" nor trailing "h").

       -r, --raw
              send the response (less the CRC field) to stdout in binary. All error messages are sent to stderr.

       -R, --report=RT
              set the 'report type' field in the SMP request. RT may take these values: 0 for report the current
              zone  manager  password  (default); 1 is reserved; 2 for report the saved zone manager password; 3
              for report the default zone manager password.

       -s, --sa=SAS_ADDR
              specifies the SAS address of the SMP target device. The mpt interface needs  this  option  and  it
              will typically be an expander's SAS address. The SAS_ADDR is in decimal but most SAS addresses are
              shown  in  hexadecimal.   To  give  a  number  in  hexadecimal either prefix it with '0x' or put a
              trailing 'h' on it.

       -v, --verbose
              increase the verbosity of the output. Can be used multiple times.

       -V, --version
              print the version string and then exit.

       Report bugs to <dgilbert at interlog dot com>.

smp_utils,smp_conf_zone_man_pass,smp_zone_lock(smp_utils)

smp_utils-0.96                                      May 2011                            SMP_REP_ZONE_MAN_PASS(8)

smp_rep_zone_man_pass  [--fpass=FP]  [--help] [--hex] [--interface=PARAMS] [--phex] [--raw] [--report=RT]
       [--sa=SAS_ADDR] [--verbose] [--version] SMP_DEVICE[,N]