slaptest - Check the suitability of the OpenLDAP slapd configuration

OpenLDAPSoftware is  developed  and  maintained  by  The  OpenLDAP  Project  <http://www.openldap.org/>.
       OpenLDAPSoftware is derived from the University of Michigan LDAP 3.3 Release.

OpenLDAP 2.6.9+dfsg-2ubuntu1                       2024/11/26                                        SLAPTEST(8)

Slaptest is used to check the conformance of the slapd(8)  configuration.   It  opens  the  slapd.conf(5)
       configuration  file  or  the  slapd-config(5)  backend,  and  parses  it according to the general and the
       backend-specific rules, checking its sanity.

       To check a slapd.conf(5) give the command:

            /usr/sbin/slaptest -f //etc/ldap/slapd.conf -v

       slaptest - Check the suitability of the OpenLDAP slapd configuration

-ddebug-level
              enable debugging messages as defined by the specified debug-level; see slapd(8) for details.

       -fslapd.conf
              specify an alternative slapd.conf(5) file.

       -Fconfdir
              specify a config directory.  If both -f and -F are specified, the config file  will  be  read  and
              converted to config directory format and written to the specified directory.  If neither option is
              specified,  slaptest  will  attempt  to read the default config directory before trying to use the
              default config file. If a valid config directory exists then the default config file  is  ignored.
              If dry-run mode is also specified, no conversion will occur.

       -ndbnum
              Just  open  and  test  the  dbnum-th  database listed in the configuration file.  To only test the
              config database slapd-config(5), use -n0 as it is always the first database.

       -ooption[=value]
              Specify an option with a(n optional) value.  Possible generic options/values are:

                     syslog=<subsystems>  (see `-s' in slapd(8))
                     syslog-level=<level> (see `-S' in slapd(8))
                     syslog-user=<user>   (see `-l' in slapd(8))

       -Q     Be extremely quiet: only the exit code indicates success (0) or not (any other value).

       -u     enable dry-run mode (i.e. don't fail if databases cannot be opened, but config is fine).

       -v     enable verbose mode.

ldap(3), slapd(8), slapdn(8)

       "OpenLDAP Administrator's Guide" (http://www.OpenLDAP.org/doc/admin/)

/usr/sbin/slaptest  [-ddebug-level] [-fslapd.conf] [-Fconfdir] [-ndbnum] [-ooption[=value]] [-Q] [-u]
       [-v]