dahdi_test — Test if the DAHDI timer provides timely response

       This  manual  page was written by Tzafrir Cohen <tzafrir.cohen@xorcom.com> Permission is granted to copy,
       distribute and/or modify this document under the terms of the GNU General Public License, Version  2  any
       later version published by the Free Software Foundation.

                                                   2005-06-25                                      dahdi_test(8)

dahdi_test  dahdi_test  runs  a timing test in a loop and prints the result of each loop.  The test is as
       follows:

       It reads 8192 bytes from the DAHDI timer device (/dev/dahdi/pseudo).  This should take exactly 8000 ms  .
       It  uses  calls  to  gettimeofday(2)  before and after that read to check that indeed exactly 8000ms have
       passed.

       Values of 100% and 99.99% Are normally considered a definite pass.   Values  of  99.98%  and  99.97%  are
       probably OK as well.

/dev/dahdi/pseudo
       The device file used to access the DAHDI timer.

       dahdi_test — Test if the DAHDI timer provides timely response

-v
              Be more verbose: print one line per test.

       -ccount
              Run for count times instead of running forever.

dahdi_tool(8), dahdi_cfg(8), asterisk(8). gettimeofday(2)

dahdi_test[-v]