git-annex-sync - synchronize local repository with remotes

       Joey Hess <id@joeyh.name>

                                                                                               git-annex-sync(1)

       This command synchronizes the local repository with its remotes.

       This  command first commits any local changes to files that have previously been added to the repository.
       Then it does the equivilant of git-annex-pull(1) followed by git-annex-push(1).

       However, unlike those commands, this command does not transfer annexed  content  by  default.  That  will
       change  in  a  future  version  of  git-annex, when syncing with repositories that have preferred content
       configured.

       git-annex-sync - synchronize local repository with remotes

--content, --no-content, -g

              The --content option causes the content of annexed files to also be pulled and pushed.

              The --no-content and -g options cause the content of annexed files to not be pulled and pushed.

              The annex.synccontent configuration can be set to true to make --content be enabled by default.

       --content-of=path-Cpath
              This option causes the content of annexed files in the given path to also be pulled and pushed.

              This option can be repeated multiple times with different paths.

              Note that this option does not prevent exporting other files to an "exporttree=yes" remote.

       --commit, --no-commit
              A commit is done by default (unless annex.autocommit is set to false).

              Use --no-commit to avoid committing local changes.

       --message=msg-mmsg
              Use this option to specify a commit message.

              If multiple -m options are given, their values are concatenated as separate paragraphs.

       --pull, --no-pull
              Use this option to disable pulling.

              When remote.<name>.annex-sync is set to false, pulling is disabled  for  that  remote,  and  using
              --pull will not enable it.

       --push, --no-push
              Use this option to disable pushing.

              When  remote.<name>.annex-sync  is  set  to  false, pushing is disabled for that remote, and using
              --push will not enable it.

       Also all options supported by git-annex-pull(1) and
              git-annex-push(1) can be used.

       Also the git-annex-common-options(1) can be used.

git-annex(1)

       git-annex-pull(1)

       git-annex-push(1)

       git-annex-assist(1)

       git-annex-satisfy(1)

       git annex sync [remote...]