pintest - GPIO Zero pintest tool

       Ben Nuttall

       2015-2024 Ben Nuttall

2.0.1                                             Feb 15, 2024                                        PINTEST(1)

       A utility for testing the function of GPIOs on a Raspberry Pi. It is possible to damage the GPIOs on a Pi
       by passing too much current (or voltage in the case of inputs) through them. The pintest utility  can  be
       used to determine if any of the GPIOs on a Pi are broken.

       The  utility  will  test all physically exposed GPIOs (those on the main GPIO header) by default, but you
       may wish to only test a subset, or to exclude certain GPIOs which can be accomplished  with  the  pintest--pins or pintest--skip options.

       NOTE:
          You  must  ensure  that  nothing  is  connected  to the GPIOs that you intend to test. By default, the
          utility will prompt you before proceeding, repeating this warning.

       In the event that any GPIO is found to be faulty, it will be reported in the output and the utility  will
       exit with a return code of 1. If all specified GPIOs test fine, the return code is zero.

       Test all physically exposed GPIOs on the board:

          $ pintest

       Test just the I2C GPIOs without prompting:

          $ pintest --pins 2,3 --yes

       Exclude the SPI GPIOs from testing:

          $ pintest --exclude GPIO7,GPIO8,GPIO9,GPIO10,GPIO11

       Note that pin numbers can be given in any form accepted by GPIO Zero, e.g. 14, GPIO14, or BOARD8.

       pintest - GPIO Zero pintest tool

       A  utility for testing the GPIO pins on a Raspberry Pi, inspired by pigpio's gpiotest example script, and
       wiringPi's pintest utility.

-h,--help
              show this help message and exit

       --version
              Show the program's version number and exit

       -pPINS,--pinsPINS
              The  pin(s)  to test. Can be specified as a comma-separated list of pins. Pin numbers can be given
              in any form accepted by gpiozero, e.g. 14, GPIO14, BOARD8. The default is to test all pins

       -sSKIP,--skipSKIP
              The pin(s) to skip testing. Can be specified as comma-separated list of pins. Pin numbers  can  be
              given in any form accepted by gpiozero, e.g. 14, GPIO14, BOARD8. The default is to skip no pins

       -y,--yes
              Proceed without prompting

       -rREVISION,--revisionREVISION
              Force  board revision. Default is to autodetect revision of current device.  You should avoid this
              option unless you are very sure the detection is incorrect

pinout(1), gpiozero-env(7)

          pintest [-h] [--version] [-p PINS] [-s SKIP] [-y] [-r REVISION]