ao-load - flash a program to a AltOS device

       Keith Packard

                                                     ao-load                                          AO-LOAD(1)

ao-load loads the specified .ihx file into the target device flash memory, customizing  the  AltOS  image
       with the specified serial number.

       ao-load - flash a program to a AltOS device

       -T tty-device | --tty tty-device
              This selects which tty device the debugger uses to communicate with the target device. The special
              name  'BITBANG' directs ao-dbg to use the cp2103 connection, otherwise this should be a usb serial
              port connected to a suitable cc1111 debug node.

       -D AltOS-device | --device AltOS-device
              Search for a connected device. This requires an argument of one of the following forms:

              TeleMetrum:2
              TeleMetrum
              2

              Leaving out the product name will cause the tool to select a suitable  product,  leaving  out  the
              serial number will cause the tool to match one of the available devices.

       -c radio-calibration | --cal radio-calibration
              This  programs  the  radio  calibration  value  into the image for hardware which doesn't have any
              eeprom storage for this value. The value here can be computed given the current radio  calibration
              value, the measured frequency and the desired frequency:

                   cal' = cal * (desired/measured)

              The default calibration value is 1186611.

ao-load  [-T  tty-device]  [--tty  tty-device]  [-D  altos-device]  [--device altos-device] [--cal radio-calibration] file.ihxdeviceserialnumber

ao-load  reads the specified .ihx file into memory, locates the matching .map file and edits the image to
       customize it using the specified serial number. It then connects  to  the  specified  target  device  and
       writes the program to the target device flash memory.