ao-rawload - flash a program to a AltOS device

       Keith Packard

                                                   ao-rawload                                      AO-RAWLOAD(1)

ao-rawload  loads  the  specified  .ihx  file,  without modification, into the target device flash or ram
       (depending on the base address of the .ihx file).

       ao-rawload - flash a program to a AltOS device

       -T tty-device | --tty tty-device
              This selects which tty device the debugger uses to communicate with the target device. The special
              name 'BITBANG' directs ao-dbg to use the cp2103 connection, otherwise this should be a usb  serial
              port connected to a suitable cc1111 debug node.

       -D AltOS-device | --device AltOS-device
              Search for a connected device. This requires an argument of one of the following forms:

              TeleMetrum:2
              TeleMetrum
              2

              Leaving  out  the  product  name will cause the tool to select a suitable product, leaving out the
              serial number will cause the tool to match one of the available devices.

       -r | --run
              After the file has been loaded, set the PC to the base address of the image and  resume  execution
              there.  the .ihx file.

ao-rawload [-T tty-device] [--tty tty-device] [-D altos-device] [--device altos-device] file.ihx

ao-rawload reads the specified .ihx file into memory. It then connects to the specified target device and
       writes the program to the target device memory and, optionally, starts the program executing.