detok - OpenBIOS detokenizer

       David L. Paktor <dlpaktor@us.ibm.com>

       This  manual page was written by Aurelien Jarno <aurel32@debian.org> for the Debian GNU/Linux system (but
       may be used by others).

                                                  May 15, 2007                                          DETOK(1)

detok  is  an  open-source  FCode detokenizer for the OpenBIOS project. It performs the reverse function,
       that is, it converts binary FCode into a form that can be read for purposes of verification.

       detok - OpenBIOS detokenizer

-h,-? Print a brief help message and then exit.

       -v,--verbose
              Print additional messages: the hex value of each token processed, as well as a signature block.

       -o     Display the positions of the tokens relative to the start of the first FCode  block  after  a  PCI
              header (if one is present), and the destination-offset of each branch.
              Note  that  the combination of the Verbose and Offsets options yields the maximum amount of useful
              information.

       -n     Display the sequential number of each line of output.
              Note that the -n and -o options are  mutually  exclusive;  if  both  are  specified,  -o  will  be
              favoured.

       -a     Do  not  stop when end0 has been encountered. This option is usually not needed, but may be useful
              in cases where a file has been corrupted or when something very strange has been tokenized...

       -fFCode-List-File
              Pre-load additional FCodes before processing. These might be,  for  instance,  a  set  of  vendor-
              specific FCodes that were generated for a specific vendor's products by a tokenizer customized for
              that specific vendor.

toke(1).

detok[options]forth-file