dmail - procmail Mail Delivery Module

       Mark Crispin, MRC@CAC.Washington.EDU

dmail  delivers  mail  to  a  user's  INBOX or a designated folder.  dmail may be configured as a drop-in
       replacement for binmail(1), mail.local(1) for use with a mail delivery filter such as procmail(1).

       Because of security considerations (see below) dmail is not intended to be used for  direct  delivery  by
       the  mailer  daemon; tmail(1) is the preferred tool for this purpose.  If dmail is used for mailer daemon
       delivery, the mailer daemon must invoke dmail with the dmail process' user id set to the recipient's user
       id.

       When dmail exits, it returns exit status values to enable procmail(1) to determine whether a message  was
       delivered  successfully  or  had a temporary (requeue for later delivery) or permanent (return to sender)
       failure.

       If the user name is present, it must be the same as the logged-in user name.

       If the +folder extension is included in the user argument (or appears by  itself  if  there  is  no  user
       argument),  dmail  will attempt to deliver to the designated folder.  If the folder does not exist or the
       extension is not included, the message is delivered to the user's INBOX.  If delivery is to INBOX and  no
       INBOX  currently exists, dmail will create a new INBOX.  dmail recognizes the format of an existing INBOX
       or folder, and appends the new message in that format.

       The -D flag specifies debugging; this enables additional message telemetry.

       The -f or -r flag is used to specify a Return-Path.  The header
          Return-Path: <from_name>
       is prepended to the message before delivery.

       The -s flag specifies that the message will be flagged as being "seen".

       The -k flag is used to specify delivery keywords, which are set on the message at delivery  time  if  and
       only  if  the keywords are already defined in the mailbox.  Multiple keywords can be specified by using a
       quoted string, e.g.,
          dmail -k "$Junk Discard" +junkbox

       dmail - procmail Mail Delivery Module

       Absolute pathnames and ~user specifications are not permitted in +folder extensions.

       Unlike tmail you can use dmail to deliver to IMAP4 namespace names via +folder  extensions.   This  means
       that it is possible to deliver to mh(1) format mailboxes.

       However,  this  can  also  include  such  namespaces as #shared, #public, and #ftp.  In most cases, it is
       undesirable to allow anybody sending mail to the user to  deliver  to  these  namespaces.   Consequently,
       there  needs  to  be a rule in place in the configuration of either sendmail(8) or procmail(1) to prevent
       such abuse.

binmail(1)
       procmail(1)

                                                  June 18, 2007                                         DMAIL(1)

dmail[-D][-ffrom_name][-s][-kkeyword_list][user][+folder]