grabserial - Serial line reader

       This manual page was written by Nobuhiro Iwamatsu <iwamatsu@debian.org>, for the Debian GNU/Linux  system
       (but may be used by others).

                                                    MAY 2015                                       GRABSERIAL(1)

Grabserial  is a small program which reads a serial port and writes the data to standard output. The main
       purpose of this tool is to collect messages written to the serial console from  a  target  board  running
       Linux, and save the messages on a host machine.

grabserial-e30-t-m^Linuxversion.*
              This  will grab serial input for 30 seconds, displaying the time for each line, and re-setting the
              base time when the line starting with "Linux version" is seen.

       grabserial - Serial line reader

-h,--help
               Print this message

       -d,--device=<devpath>
               Set the device to read (default '/dev/ttyS0')

       -b,--baudrate=<val>
               Set the baudrate (default 115200)

       -w,--width=<val>
               Set the data bit width (default 8)

       -p,--parity=<val>
               Set the parity (default N)

       -s,--stopbits=<val>
               Set the stopbits (default 1)

       -x,--xonxoff
               Enable software flow control (default off)

       -r,--rtscts
               Enable RTS/CTS flow control (default off)

       -f,--force-reset
               Force pyserial to reset device parameters

       --endtime=<secs>
               End the program after the specified seconds have elapsed.

       --command=<cmd>
               Send a command to the port before reading

       -t,--time
               Print time for each line received.  The time is
               when the first character of each line is
               received by grabserial

       --systime
               Print system time for each line received. The time
               is the absolute local time when the first character
               of each line is received by grabserial

       -m,--match=<pat>
               Specify a regular expression pattern to match to
               set a base time.  Time values for lines after the
               line matching the pattern will be relative to
               this base time.

       -i,--instantpat=<pat>
               Specify a regular expression pattern to have its time
               reported at end of run.  Works mid-line.

       -q,--quitpat=<pat>
               Specify a regular expression pattern to end the
               program. Works mid-line.

       -l,--launchtime
               Set base time from launch of program.

       -o,--output=<name>
               Output data to the named file.

       -v,--verbose
               Show verbose runtime messages

       -V,--version
               Show version number and exit

grabserial

       grabserial [options] <config_file>