GTKTerm - A simple GTK+ serial port terminal

gtkterm  was written by Julien Schmitt.  Maintained at https://github.com/Jeija/gtkterm by Willem van den
       Akker, Florian Euchner

       This manual page was written by Sebastien Bacher <seb128@debian.org>, for  the  Debian  GNU/Linux  system
       (but may be used by others).

                                               September 15, 2019                                     GTKTerm(1)

gtkterm is a simple GTK+ terminal used to communicate with the serial port.

       GTKTerm - A simple GTK+ serial port terminal

gtkterm accepts the following options:

       -h,--help Help screen.

       -c,--config<configuration>
              Load configuration (default is "default").

       -p,--port<device>
              Serial port device (default /dev/ttyS0).

       -s,--speed<speed>
              Serial port speed (default 115200).

       -b,--bits<bits>
              Number of bits (default 8).

       -t,--stopbits<stopbits>
              Number of stopbits (default 1).

       -a,--parity<odd|even>
              Partity (default none).

       -w,--flow<Xon|CTS>
              Flow control (default none).

       -d,--delay<ms>
              End of line delay in ms (default none).

       -r,--char<char>
              Wait for a special char at end of line (default none).

       -f,--file<filename>
              Default file to send (default none).

       -e,--echo
              Set local echo.

       -x,--rts_time_before<ms>
              For rs485, time in ms before transmit with rts on

       -y,--rts_time_after<ms>
              For rs485, time in ms after transmit with rts on

       -e,--echo
              Switch on local echo

       -L,--disable-port-lock
              Do not lock serial port. Allows to send to serial port from different terminals.

gtkterm[options]