jt9 - processes JT4/9/65, FT8 and QRA64 information in wav files

       This manual page was written by Dave Hibberd <d@vehibberd.com>

1.8.0                                             February 2018                                           JT9(1)

              Reads data from *.wav files.

              jt9 -s <key> [-w patience] [-m threads] [-e path] [-a path] [-t path] Gets data from shared memory
              region with key==<key>

       jt9 -  processes JT4/9/65, FT8 and QRA64 information in wav files

-h--help
           Display this help message

       -s KEY
       --shmem KEY
           Use shared memory for sample data

       -p MINUTES
       --tr-period MINUTES
           Tx/Rx period, default MINUTES=1

       -e PATH
       --executable-path PATH
           Location of subordinate executables (KVASD) default PATH="."

       -a PATH
       --data-path PATH
           Location of writeable data files, default PATH="."

       -t PATH
       --temp-path PATH
           Temporary files path, default PATH="."

       -L HERTZ
       --lowest HERTZ
           Lowest frequency decoded (JT65), default HERTZ=200

       -H HERTZ
       --highest HERTZ
           Highest frequency decoded, default HERTZ=4007

       -S HERTZ
       --split HERTZ
           Lowest JT9 frequency decoded, default HERTZ=2700

       -f HERTZ
       --rx-frequency HERTZ
           Receive frequency offset, default HERTZ=1500

       -w PATIENCE
       --patience PATIENCE
           FFTW3 planing patience (0-4), default PATIENCE=1

       -m THREADS
       --fft-threads THREADS
           Number of threads to process large FFTs, default THREADS=1

       -6--jt65
           JT65 mode

       -9--jt9
           JT9 mode

       -8--ft8
           FT8 mode

       -4--jt4
           JT4 mode

       -q--qra64
           QRA64 mode

       -b A
       --sub-mode A
           Sub mode, default SUBMODE=A

       -d DEPTH
       --depth DEPTH
           JT9 decoding depth (1-3), default DEPTH=1

       -T--tx-jt9
           Tx mode is JT9

       -c CALL
       --my-call CALL
           my callsign.HP

       -G GRID
       --my-grid GRID
           my grid locator

       -x CALL
       --his-call CALL
           Their callsign

       -g GRID
       --his-grid GRID
           Their grid locator

       -X FLAGS
       --experience-decode FLAGS
           experience based decoding flags (1..n), default FLAGS=0

       The  full  documentation  for  jt9  is  maintained as a Texinfo manual.  If the info and jt9 programs are
       properly installed at your site, the command

              infojt9

       should give you access to the complete manual.

       Usage: jt9 [OPTIONS] file1 [file2 ...]