mlabel - make an MSDOS volume label

       The mlabel command adds a volume label to a disk. Its syntax is:
       mlabel [-vcsn] [-N serial] drive:[new_label]

       Mlabel displays the current volume label, if present. If new_label is not given, and if neither the c nor
       the s options are set, it prompts the user for a new volume label.  To delete an existing  volume  label,
       press return at the prompt.

       The label is limited to 11 single-byte characters, e.g. Name1234567.

       Reasonable care is taken to create a valid MS-DOS volume label.  If an invalid label is specified, mlabel
       changes the label (and displays the new label if the verbose mode is set). Mlabel returns 0 on success or
       1 on failure.

       Mlabel supports the following options:

       c      Clears an existing label, without prompting the user

       s      Shows the existing label, without prompting the user.

       n      Assigns a new (random) serial number to the disk

       N serial
              Sets  the  supplied  serial number. The serial number should be supplied as an 8 digit hexadecimal
              number, without spaces

       mlabel - make an MSDOS volume label

       This  manpage  has  been  automatically  generated  from  mtools's  texinfo documentation, and may not be
       entirely accurate or complete.  See the end of this man page for details.

       Mtools' texinfo doc

       This manpage has been automatically generated from mtools's texinfo documentation. However, this  process
       is  only  approximative,  and some items, such as crossreferences, footnotes and indices are lost in this
       translation process.  Indeed, these items have no  appropriate  representation  in  the  manpage  format.
       Moreover,  not  all information has been translated into the manpage version.  Thus I strongly advise you
       to use the original texinfo doc.  See the end of this manpage for instructions how to  view  the  texinfo
       doc.

       *      To generate a printable copy from the texinfo doc, run the following commands:

                     ./configure;makedvi;dvipsmtools.dvi

       *      To generate a html copy,  run:

                     ./configure;makehtml

       A premade html can be found at `http://www.gnu.org/software/mtools/manual/mtools.html'

       *      To generate an info copy (browsable using emacs' info mode), run:

                     ./configure;makeinfo

       The  texinfo doc looks most pretty when printed or as html.  Indeed, in the info version certain examples
       are difficult to read due to the quoting conventions used in info.

mtools-4.0.48                                        22Feb25                                           mlabel(1)