traceends - summarise traffic done by every endpoint observed in a trace

       Shane Alcock <salcock@cs.waikato.ac.nz>

traceends (libtrace)                             September 2011                                     TRACEENDS(1)

       traceends  reports  the  number  of  bytes and packets sent and received by each endpoint observed in the
       input trace(s). Usually, you don't want to run this program directly -- see tracetopends instead.

       -f bpf filter
              output only packets that match tcpdump style bpf filter

       -A address type
              Specifies how an endpoint should be defined. Suitable options are "mac", "v4" and "v6" which  will
              report endpoint stats for each observed MAC address, IPv4 address and IPv6 address respectively.

       Get stats for each individual MAC address in a trace:
       traceends -a mac erf:trace.erf.gz

       More       details      about      traceends      (and      libtrace)      can      be      found      at
       http://www.wand.net.nz/trac/libtrace/wiki/UserDocumentation

       traceends - summarise traffic done by every endpoint observed in a trace

       Output is written to stdout in columns separated by blank space.

       The columns are (in order):
        * Endpoint address
        * Time last observed
        * Packets originating from the endpoint
        * Bytes originating from the endpoint (IP header onwards)
        * Payload originating from the endpoint (post transport header)
        * Packets sent to the endpoint
        * Bytes sent to the endpoint (IP header onwards)
        * Payload sent to the endpoint (post transport header)

libtrace(3),   tracemerge(1),   tracefilter(1),   traceconvert(1),   tracesplit_dir(1),   tracereport(1),
       tracertstats(1),   tracestats(1),   tracepktdump(1),   traceanon(1),   tracesummary(1),   tracereplay(1),
       tracediff(1), tracetopends(1)

tracetopends [ -f bpf | --filter=bpf] [ -a addrtype | --address=addrtype] [ -H|--help]inputuri[inputuri...]