tracetopends - reports the endpoints that are responsible for the most traffic in a trace

       Shane Alcock <salcock@cs.waikato.ac.nz>

tracetopends (libtrace)                          September 2011                                  TRACETOPENDS(1)

       tracetopends reports the number of bytes and packets sent and received by the busiest endpoints  observed
       in the input trace(s).

       -f bpf filter
              Output only packets that match tcpdump style bpf filter.

       -n top count
              Report the top N endpoints (defaults to 10).

       -A address type
              Specifies  how an endpoint should be defined. Suitable options are "mac", "v4" and "v6" which will
              report endpoint stats for each observed MAC address, IPv4 address and IPv6 address respectively.

       -s     Sort endpoints based on the amount of outgoing traffic (will cancel any previous -d  option.  This
              is on by default.

       -d     Sort endpoints based on the amount of incoming traffic (will cancel any previous -s option.

       -b     Sort  endpoints based on the amount of IP traffic (will cancel any previous -a or -p options. This
              is on by default.

       -a     Sort endpoints based on the amount of application layer traffic (will cancel any previous -b or -p
              options.

       -p     Sort endpoints based on the amount of packets (will cancel any previous -b or -a options.

       Find the IPv4 addresses that are sending the most traffic.
       tracetopends -A v4 -b -s erf:trace.erf.gz

       More     details     about      tracetopends      (and      libtrace)      can      be      found      at
       http://www.wand.net.nz/trac/libtrace/wiki/UserDocumentation

       tracetopends - reports the endpoints that are responsible for the most traffic in a trace

       Output is written to stdout in columns separated by blank space.

       The columns are (in order):
        * Endpoint address
        * Time last observed
        * Packets originating from the endpoint
        * Bytes originating from the endpoint (IP header onwards)
        * Payload originating from the endpoint (post transport header)
        * Packets sent to the endpoint
        * Bytes sent to the endpoint (IP header onwards)
        * Payload sent to the endpoint (post transport header)

libtrace(3),   tracemerge(1),   tracefilter(1),   traceconvert(1),   tracesplit_dir(1),   tracereport(1),
       tracertstats(1),   tracestats(1),   tracepktdump(1),   traceanon(1),   tracesummary(1),   tracereplay(1),
       tracediff(1), traceends(1)

tracetopends  [  -f  bpf  ]  [  -A addrtype ] [ -s][-d][-b][-a][-p][-n topcount ] inputuri
       [inputuri ...]