gnunet-ats — display information about transport resource allocation

       Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨bug-gnunet@gnu.org⟩.

Debian                                          October 16, 2015                                   GNUNET-ATS(1)

gnunet-ats can be used to display information about the GNUnet's transport selection mechanism.  It shows
       information about the addresses and the assigned input and output bandwidth.

       gnunet-ats — display information about transport resource allocation

-a | --all
               List all addresses currently known to ats.

       -CPEERID | --connect=PEERID
               Ask ATS to suggest an address for PEERID to transport to establish a connection.  Note  that  you
               can use the gnunet-transport(1) commandline tool to force disconnects.

       -cFILENAME | --config=FILENAME
               Use the configuration file FILENAME.

       -h | --help
               Print short help on options.

       -iPEERID | --id=PEERID
               Print information for a specific peer identity only.

       -kVALUE | --value=VALUE
               Value to set for when changing preference values.

       -LLOGLEVEL | --loglevel=LOGLEVEL
               Use LOGLEVEL for logging.  Valid values are DEBUG, INFO, WARNING and ERROR.

       -m | --monitor
               Monitor changes to the bandwidth assignments continuously.

       -n | --numeric
               Do not resolve IP addresses to hostnames.

       -pPREFERENCE | --preference=PREFERENCE
               Set preference values, -i, -k and -t required.

       -q | --quotas
               Print quotas for all network types

       -tTYPE | --type=TYPE
               Preference type to change: latency | bandwidth

       -u | --used
               Print addresses actively used only

       -V | --verbose
               Print verbose output (include ATS address properties)

       v | -version
               Print GNUnet version number.

gnunet-transport(1)

       The  full documentation for gnunet is maintained as a Texinfo manual.  If the info(1) and gnunet programs
       are properly installed at your site, the command

             infognunet

       should give you access to the complete handbook,

             infognunet-c-tutorial

       will give you access to a tutorial for developers.

       Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).

gnunet-ats  [-a  |  --all] [-CPEERID | --connect=PEERID] [-cFILENAME | --config=FILENAME] [-h | --help]
                  [-iPEERID | --id=PEERID] [-kVALUE  |  --value=VALUE]  [-LLOGLEVEL  |  --loglevel=LOGLEVEL]
                  [-m  |  --monitor]  [-n | --numeric] [-pPREFERENCE | --preference=PREFERENCE] [-q | --quotas]
                  [-tTYPE | --type=TYPE] [-u | --used] [-V | --verbose] [-v | --version]