tmd710_tncsetup - tool to configure the TNC on several Kenwood radios

       Written by Francois Marier <va7gpl@fmarier.org>

       Project Homepage: https://github.com/fmarier/tmd710_tncsetup

                                                   3 Jan 2021                                 tmd710_tncsetup(1)

       This manual page documents briefly the tmd710-tncsetup command.

       tmd710_tncsetup - tool to configure the TNC on several Kenwood radios

       These  programs  follow  the  usual  GNU  command line syntax, with long options starting with two dashes
       (`-').  A summary of options is included below.  You must supply at least two arguments: the band (0  for
       Band A, 1 for Band B) and the serial port

       -B,--band
              the frequency band to use (0 for Band A or 1 for Band B)

       -S,--serialport
              the serial port to use for communication with the operation panel

       -b,--baudrate
              sets the HBAUD parameter (TNC speed, 1200 or 9600 baud)

       -m,--maxframe
              sets the MAXFRAME parameter (1-7)

       -p,--paclen
              sets the PACLEN parameter (0-255)

       -d,--txdelay
              sets the TXDELAY parameter (0-120)

       -s,--software-flow
              configure the TNC for software flow-control

       -h,--hardware-flow
              configure the TNC for hardware flow-control

       -c,--callsign
              configure the callsign

       -i     Initialize TNC (default is into Packet KISS mode) 1 : TNC off 2 : Packet command mode only

       -V,--version
              display the version

tmd710_tncsetup [options]