trace-cmd-listen - listen for incoming connection to record tracing.

       Written by Steven Rostedt, <rostedt@goodmis.org[1]>

       Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted under the terms of the GNU Public
       License (GPL).

       The trace-cmd(1) listen sets up a port to listen to waiting for connections from other hosts that run
       trace-cmd-record(1) with the -N option. When a connection is made, and the remote host sends data, it
       will create a file called trace.HOST:PORT.dat. Where HOST is the name of the remote host, and PORT is the
       port that the remote host used to connect with.

       trace-cmd-listen - listen for incoming connection to record tracing.

        1. rostedt@goodmis.orgmailto:rostedt@goodmis.org

libtracefs                                         04/08/2024                                TRACE-CMD-LISTEN(1)

-pport
           This option will specify the port to listen to.

       -D
           This options causes trace-cmd listen to go into a daemon mode and run in the background.

       -V
           Listen on a vsocket instead. This is useful for tracing between host and guest VMs.

       -ddir
           This option specifies a directory to write the data files into.

       -ofilename
           This option overrides the default trace in the trace.HOST:PORT.dat that is created when a remote host
           connects.

       -lfilename
           This option writes the output messages to a log file instead of standard output.

       --verbose[=level]
           Set the log level. Supported log levels are "none", "critical", "error", "warning", "info", "debug",
           "all" or their identifiers "0", "1", "2", "3", "4", "5", "6". Setting the log level to specific value
           enables all logs from that and all previous levels. The level will default to "info" if one is not
           specified.

               Example: enable all critical, error and warning logs

               trace-cmd listen --verbose=warning

https://git.kernel.org/pub/scm/utils/trace-cmd/trace-cmd.git/

trace-cmd(1), trace-cmd-record(1), trace-cmd-report(1), trace-cmd-start(1), trace-cmd-stop(1),
       trace-cmd-extract(1), trace-cmd-reset(1), trace-cmd-split(1), trace-cmd-list(1)

trace-cmdlisten -p port [OPTIONS]