pts_sleep - Pauses for a few seconds

       Prior to OpenAFS 1.4.5 and OpenAFS 1.5.23, the ptssleep command was only available on Unix or Linux and
       when OpenAFS was compiled with the supergroups option (disabled by default).  As of OpenAFS 1.4.5 and
       1.5.23, it is always available.

       Copyright 2007 Jason Edgecombe <jason@rampaginggeek.com>

       This documentation is covered by the BSD License as written in the doc/LICENSE file. This  man  page  was
       written by Jason Edgecombe for OpenAFS.

OpenAFS                                            2025-03-21                                       PTS_SLEEP(1)

       The ptssleep pauses for a specified number of seconds. The command can be run from the command line or
       interactively, although from the command line it's essentially equivalent to the sleep command. It is
       intended for use in interactive mode to pause for a few seconds between batch commands to allow the
       Protection Server to catch up.

       Here is an example of a ptsinteractive session:

          % pts interactive
          pts> sleep 5
          pts> quit
          %

       pts_sleep - Pauses for a few seconds

       Although they have no effect, ptssleep takes the following standard pts options:

       -delay <#ofseconds>
           Specifies the amount of time to sleep, in seconds.

       -auth
           Use  the  calling  user's  tokens  to  communicate  with the Protection Server. For more details, see
           pts(1).

       -cell <cellname>
           Names the cell in which to run the command. For more details, see pts(1).

       -config <configdirectory>
           Use an alternate config directory. For more details, see pts(1).

       -encrypt
           Encrypts any communication with the Protection Server. For more details, see pts(1).

       -force
           Enables the command to continue executing as far as possible when errors  or  other  problems  occur,
           rather than halting execution at the first error.

       -help
           Prints the online help for this command. All other valid options are ignored.

       -localauth
           Constructs  a  server  ticket  using  a  key  from the local /etc/openafs/server/KeyFile file. Do not
           combine this flag with the -cell or -noauth options. For more details, see pts(1).

       -noauth
           Assigns the unprivileged identity anonymous to the issuer. For more details, see pts(1).

       This command produces no output.

pts(1), pts_interactive(1)

ptssleep [-delay] <#ofseconds>
          [-cell] <cellname> [-noauth] [-localauth] [-force]
          [-help] [-auth] [-encrypt] [-config <configdirectory>]

       ptssl [-d] <#ofseconds> [-c] <cellname>
          [-n] [-l] [-f] [-h]
          [-a] [-e] [-co <configdirectory>]